01 / ANGLEWhy start near 45°?
A 45° wrap is a common teaching reference. It balances coil spacing and wire use on the ideal cylinder. Work from an anchored base toward the branch tip and keep the spacing deliberate. There is no universally safe angle for every species and branch.
02 / GAUGEChoose wire by a gentle trial.
Aluminum is easier to handle for many beginners; annealed copper is stiffer and requires different handling. Aluminum around one-third of the branch diameter is a starting rule of thumb, not a strength calculation. Test whether the wire holds a modest bend without forcing the branch.
03 / AFTERCAREWatch growth, not the calendar.
Inspect wired branches regularly, especially during active growth. Swelling and marks can mean the wire is cutting into the bark. Remove by cutting each coil with a suitable cutter rather than pulling or unwinding the whole wire. Inspection and removal timing depend on species and growth.
The geometry behind the drawing
P = π(D + w) / tan θ · N = L / P · S = L / cos θ
D = branch diameter, w = wire diameter, L = branch length. P is axial pitch, N is turns, and S is helix centerline length. All dimensions use millimeters. Cut estimate = 1.20 × S + your anchor allowance. The 20% margin is a fixed planning assumption, not a species recommendation. Adjust the separate anchor allowance for extra length.
Uniform cylinder, no taper, no branch curvature. Numbers describe geometry only. They cannot predict breakage, bark compression, growth or holding strength.